|
Firmware Version 1.11 for UFS 821si (Order no. 20210071) and UFS 821sw (Order no. 20210072)
The following improvements and new functions are available with the new software version 1.1:
- EPG SI-data for RTL is again available
- Freezing after EPG call-up on the programme BR-alpha and on SR TV and radio programmes
Note:
Check the order no. of your device. The order no. can be found on the receiver’s rear panel.
Loading incorrect firmware can cause damage to your receiver.
Firm and Software for the UFS 821
DVR manager for Windows 2000, XP
Programme to
- Transfer firmware and programme tables
- Read out and editing of programme tables
- Transfering pictures and MP3 files
- Transfering video and audio data onto a PC
- Transfer games
The installation and use of this software is described in the user manual in the section "DVR manager".
|
Older Firmware Versions: |
ufs821_v1.10.img, Version 1.10, 11/2008
- New tvtv - library integrated
- Improvement: double entries, e.g. ORF 2
- Database error by to high data volume
- One cable system for eight addresses
|
ufs821_v1.09.img, Version 1.09, 03/2008
Improvements:
- Green wiper effect with 16:9 transmissions on 4:3 TV-sets reduced
- Saving of last menu position
- Remote control code now settable using the menu "System parameter/Receiver management", e.g. Code 2 (EXIT + 2).
Each time the receiver is activated the actually active remote control code will be displayed
- File in recording archive
- General stability improvement
|
ufs821_v1.05.img, Version 1.05, 04/2007
Improvements:
- Diverse errors have been solved and other general improvements made possible
- Twin recording problem with multi-feed reception systems is solved
- Problem with ORF recordings is solved
- AV synchronity problem is solved (specifically for ORF)
- Possibility to switch the function "Dynamic SI handling" on or off is now available
- Brightness settings for the front display have been improved
- Possibility to switch the radio text on or off is now available
- General improvements when using the radio text function
- Radio audio problem is now solved
- Recording with parallel signal availability on both the TV and VCR SCART outputs. The pre-requisite for this recording possibility via the VCR socket is that the receiver must be switched on when the programme starts, and be set to the programme which is to be recorded - further that during recording the remote control must not be used, otherwise called up menu screen-shots will also be recorded
- Extension of the audio tone in the option menu
- Radio markers can be removed - to do this press down the blue TV/R key - Screen shot "Clear marker?" is displayed
- Information on the installed sys-file is now included in the menu System information
- Stability of the copy process (MP3, pictures) from an external unit to the internal hard disk has been improved
|
ufs821_v1.04.img, Version 1.04, 09/2006
With the firmware version 1.04 we have solved specific problem when receiving a Radio programme. |
ufs821_fw1.02.zip, Version 1.02, 05/2006
Improvements
- Solving of all known software problems
- Improved read-in speeds for MP3 and JPEG files
New Software functions
- Audio track signaling
- Display dimmer function
- Setting of pre-run and post-run time span for ach recording
- Decoding for One Touch Recording
- Multiple decoding
- A/V settings integrated in first installation menu
- Multi-feed channels can be called up over the menu
- Slow motion function in recording-display mode
|
UFS821_FW1.01.zip, Version 1.01, 02/2006
Improvements
- RGB green tinge in some TV sets solved
- Audio problems in Radio operation solved
- Improvement of One Touch Recording with Option "Later"
- Volume bars corrected
- Tele-text problems solved
- Time-shift buffer improved
New Software functions
- Direct decoding of tvtv timers
- Cut function - after any cut-off action re-viewing starts from where recoding was started
- PIN Code input for EPG recording
- Bookmarks also possible during recording
- Recordings of parentally locked channels are marked in the recording archive as locked recordings - PIN entry is required to view
- MP3 title in display - when the MP3 file includes no ID3 tag the file name is shown in the display
- Coded recordings decoded in Stand-by - original file stays initially after decoding in Stand-by on the hard disk and can /must afterwards be manually deleted by the user
|
|