|
Firmware-Version 2.05 for UFD 580 (Order no. 20210024) and UFD 580/S (Order no. 20210025)
Changes:
- Hard disk > 120 GByte is supported
- Double programming is considered in the EPG
- When starting an automatic recording the original programme is reverted to
- Handling problems have been improved
- Counter has been included in the tvtv acquisition display
Note:
Check the order no. of your device. The order no. can be found on the receiver’s rear panel.
Loading incorrect firmware can cause damage to your receiver.
Required Accessories:
Connection cable PC to receiver: crossed RS 232 cable (Null modem cable).
Click here to order accessories
|
Older Firmware Versions: |
ufd580_v204.zip
, Version 2.04, 1235 kByte, 09/2005
- Hard disk < 200 GByte is supported
- Handling problems have been improved
- Switch back to the the original programme when starting an automatic recording
- Double programming is considered in the EPG
|
ufd580_v203.zip
, Version 2.03, 1231 kByte, 06/2005
- Improvement of tvtv EPG stability
- Transmission of radio recordings using an USB tool (Version 0.9.5) enabled
|
ufd580_v202.zip
, Version 2.02, 1227 kByte, 03/2005
- Summer/Winter time problematic cleared
- Marking of coded programmes in the EPG menu
- Any programme position movement is immediately actualised in the EPG menu
- Scrolling capability in the EPG menu
- P+/P keys allow setting in 24 hour steps
- AC3 and DolbyDigital improved
|
ufd580_v201.zip
, Version 2.01, 1214 kByte, 02/2005
- Optimising of the tvtv data bank
|
| ufd580_v200.zip
, Version 2.00, 1216 kByte, 01/2005 |
| ufd580_v103.bin
, Version 1.03, 1262 kByte, 10/2004 |
| ufd580_v102.bin
, Version 1.02, 1958 kByte, 08/2004 |
Software to transfer the hard disk contents to a PC over the USB interface
New: Version 0.9.5
Changes made from the original software version 0.9.2:
- Transmission of radio recordings (SW status V2.03 is required in the receiver)
- Progress bar available
- Application can be minimised
- Transmission can be stopped
Should you have any problems when installing the transfer programme or drivers, please contact your PC specialist.
Programme tables
Note:
when loading the new programme tables the previously saved programme sequency will be overwritten.
|