We donīt take on liability for damages during the recording of the firmware at the MSK 33

Please pay attention to the instructions of the manual. This manual is also included in the software. Please also pay attention to the modifications of version 9.0

Connection & Cabling for the Update procedure of MSK 33/ G / Q / M / TM / TMR / etc.

msk33v90.zip (compressed) Firmware, graphic-card software, manual and modifications.

msk33v90.bin (not compressed) Only Firmware

For not compressed version of the graphic-card software please click here. Only graphic-card software

The firmware 8.5 or heigher requires the graphic software FPGA V3.0

The graphic software is downloaded into the MSK 33 in the same manner as the firmware. It is imperative to observe, that the command "bin" is not entered in but rather " fpga" after the command "unl" to load the software.

The new graphic software FPGA V3.0 does not work with MSK 33 software status V6.3 or lower.

In case of problems with recording the new firmware, please contact the hotline of
KATHREIN-Werke KG, Rosenheim, phone +43 8031 184700